Wszystkie wiadomości

Q: what voltage for motor?

zapytał BG363514129 na 2020-11-06 05:47:11

LeoLuis 2400kv 4s and 1950kv 6s

2020-11-06 06:43:57 Pomocny (0)
Zatwierdź
odpowiedzi (2)

LeoLuis U can try 4s with motor output limit to 2400kv and see how it handles it. If no desync, u should be ok with 2600kv. Most likely will handle 6s too but max 1800kv

2020-10-19 09:51:05 Pomocny (0)
Zatwierdź
odpowiedzi (1)

Q: can i fly *****kv motors on 6s? can handle it? xiexie

zapytał LeoLuis na 2020-10-02 01:40:24

Hobbyboy yes you can use these just don't over prop the motors, or run the motor full throttle all the time and they will be fine

2020-10-02 06:45:25 Pomocny (0)
Zatwierdź
odpowiedzi (2)

LeoLuis They dont work on 6s, they will get very hot or the motors wont spin as they should. At 1st I thought the esc burned but then, on 4s, the motors will spin normally. This would be an awesome product only if... well, stick to holybro tekko32 or Spedix es30. Those will fly 6s like charm

2020-09-24 10:07:50 Pomocny (0)
Zatwierdź
odpowiedzi (8)

Q: What KV is the limited with 6s?

zapytał KuriOSS na 2019-10-26 09:02:00

LeoLuis 2408 1900kv? Possible?

2020-06-24 09:59:25 Pomocny (0)
Zatwierdź
odpowiedzi (4)

Q: can this stack handle large motors like *****kv or *****kv?

zapytał LeoLuis na 2020-05-28 08:16:27

Blenno phobia 3-6S input can be compatibled.

2020-06-02 01:16:16 Pomocny (0)
Zatwierdź
odpowiedzi (1)

Q: when will this be available?

zapytał LeoLuis na 2019-05-03 03:14:36

cob2791 Ihaven't seen your question. I think now it's available;)

2020-05-15 01:35:01 Pomocny (0)
Zatwierdź
odpowiedzi (1)

stevenlipinski i used the tx4 and rx4 pads on top of the FC and the 5v and ground on the bottom of the board. Then just go in to ports tab in beta flight and configure uart 4 as rx serial. and change protocol to crfs. Do not use the uart 3 as this is used for smart audio for vtx.

2019-09-19 12:20:25 Pomocny (3)
Zatwierdź
odpowiedzi (2)

Q: hero7 fits in?

zapytał LeoLuis na 2019-11-18 10:13:37

Piggyg0u7 Yes.

2019-12-04 02:59:54 Pomocny (0)
Zatwierdź
odpowiedzi (1)

LeoLuis They may get it from another seller that its in the list? 🤷🏻‍♂️

2018-09-01 02:43:49 Pomocny (0)
Zatwierdź
odpowiedzi (1)

LeoLuis Yes it will vibrate and will display “game over” in the LCD.

2018-07-17 09:24:18 Pomocny (1)
Zatwierdź
odpowiedzi (11)

Q: fs-i6 compatible?

zapytał LeoLuis na 2018-03-06 11:31:28

Jason HM Compatible ,, FS-I6 with AFHDS-2A protocol

2018-03-14 09:16:20 Pomocny (0)
Zatwierdź
odpowiedzi (1)