Wszystkie wiadomości

hersch710 firmware target in bataflight is omnibusf4sd

2018-01-19 05:20:23 Pomocny (4)
Zatwierdź
odpowiedzi (10)

Kekuj Maybe you can use the "contact us " to contact the banggood customer service team to help you.

2018-05-29 10:45:10 Pomocny (0)
Zatwierdź
odpowiedzi (1)

tfuse Your answer is a joke... I still do not know what FIRMWARE target to flash onto this board in Betaflight. Troll on

2017-12-30 09:37:46 Pomocny (0)
Zatwierdź
odpowiedzi (10)

tfuse you can wire 5v either where you've mentioned or via the plug terminal underneath the board near the SD card reader. this allows you to make a super clean build with an ESC that has a plug terminal as well.

2017-12-28 02:21:34 Pomocny (0)
Zatwierdź
odpowiedzi (1)

prylmannen Did you get voltage shown in Betaflight with this board? I powered it thru 5v but can´t get any voltage info. You used the connector to get it working?

2018-04-05 02:02:03 Pomocny (0)
Zatwierdź
odpowiedzi (1)

tfuse It's powered from a 5v input. The input is either on the bottom of the board (as oriented in the 1st photo) or powered on the underside board with the supplied cable. This board can be used for either 4in1 ESCs or 4 independent ESCs.

2017-11-26 09:27:05 Pomocny (0)
Zatwierdź
odpowiedzi (1)