Wszystkie wiadomości

Q: can anyone please tell me if this antenna will increase range?

zapytał DannyThomson na 2022-02-10 06:00:10

Daithi In comparison to the standard 'rubber duck', yes it will.However, any gain in a built up area will be minimal but this is due to attenuation caused by buildings, power lines, etc. Gain would be noticable in a rural setting

2022-02-10 07:05:52 Pomocny (0)
Zatwierdź
odpowiedzi (1)

Daithi It's not a problem with the machine per se but what I would recommend is that you attach it (lightly glue the feet) to a piece of plasterboard (dry wall to the US) so that it doesn't move around while in use. Again, attaching the work piece with either double sided tape or blu-tak will help to prevent any accidental movement during the burn process

2022-01-13 09:50:12 Pomocny (5)
Zatwierdź
odpowiedzi (5)

Daithi Sdrsharp from airspy dot com works fine for me If you want to monitor data on the ham bands, you need an app like fldigi which will decode the signals such as Morse Code, PSK, PACTOR, and a lot more

2021-12-19 11:47:03 Pomocny (1)
Zatwierdź
odpowiedzi (2)

Daithi Yes to both with the caveat that you will probably have to go over the MDF a few times. Just make sure it stays in place during and between passes of the laser (stick it down with double sided tape, blu-tack or anything that will stop it moving)

2021-10-31 12:31:50 Pomocny (3)
Zatwierdź
odpowiedzi (4)

Daithi It depends on the material. From the manual, do NOT cut Polycarbonate, PVC, Polystyrene, Polypropylene, ABS or HDPE. The manual can be obtained from the sculpfun website under support

2021-10-22 03:35:14 Pomocny (1)
Zatwierdź
odpowiedzi (5)

Q: sculpfun A*****w is better them the Atomsta A*****w?

zapytał BG401370174 na 2021-10-11 05:04:01

Daithi Because A6 is double the area of A5. Think paper sizes (A3, A4...)

2021-10-11 06:38:12 Pomocny (0)
Zatwierdź
odpowiedzi (1)