Sarcoise
moje treści
Wszystkie wiadomości
Opinie
Komentarze
odpowiedzi
pytania

Wszystkie wiadomości

100g 63/37 0,6 / 0,8 / 1,0 / 1,2 / 1,8 mm Szpula z drutem lutowniczym z cyny Rdzeń kalafoniowy
US$4.59 US$11.99

Q: Is this solder leaded/tin alloy? Meaning does it contain lead? This is important for small electronic solder jobs to have lead as tin has a much higher melting point!

zapytał Sarcoise na 2018-03-22 02:12:55

Carlosmiraes BAJA CALIDAD NO,MUY ,MALA.IMPOSIBLE SOLDAR SI NECESITAS BAJA TEMEPRATURA DE FUSIÓN.ES IGUAL QUE APLIQUES FLUX.EL PRODUCTO NO SIRVE.

2021-01-21 02:07:19 Pomocny (3)
Zatwierdź
odpowiedzi (5)
10 zestawów 15cm XH2.54 8-pinowy 24AWG 1007 Przewód terminalowy łączący płytkę obwodową z gniazdem
US$9.23 US$9.99

Q: Can anyone verify if item received is like pictures? i.e. 7pin female / 8pin male. Maybe the pics are wrong?

zapytał Sarcoise na 2018-04-09 02:46:44

KIRASE I got of these also. Gee I'm mad. The Female is 7 Pins and the Male is 8-Pins. THEY DON'T MATCH?

2020-10-08 04:52:28 Pomocny (1)
Zatwierdź
odpowiedzi (2)
Sarcoise 06/07/2018
Used to extend the receiving portion of the antenna so it could be mounted away from the carbon fiber frame. The result was a DSM satellite receiver that has a longer antenna (like FrSky RXs) which can be placed to improve reception. Make sure to run the shielding to a ground point (I used the ground where the plug enters the RX board between the positive and signal, extended it with a wire to the antenna contact point to ground the shielding) did several range test, works great. This does not extend range, only extends the receiving portion of the antenna where it can be mounted away from the carbon fiber frame - similar to the RX wires on Frsky.
10szt 2.4G Antena odbiornika RF113 srebrzona długości 15cm
US$9.19 US$18.99
1
Zalecenia
Komentarze (0)
Sarcoise 13/12/2018
Exactly what title says, worked perfect. Used with my triple feed patch antenna.
5PCS/10PCS SMA Męski Zakończenie Dopasowana Attrapa 50 Ohm Terminator Do FPV RC Drone
US$17.31 US$17.99
0
Zalecenia
Komentarze (0)
Sarcoise 13/12/2018
Gives me great range at a decent path.
Realacc Triple Feed Patch-1 5,8 GHz 9.4dBi Kierunkowa antena cyrkularnie spolaryzowana FPV Pagoda dla Fatshark DJI Eachine Gogle
US$15.55 US$26.39
0
Zalecenia
Komentarze (0)
Sarcoise 13/12/2018
Have used these as basher props for a while now, love the price vs performance. They provide great throttle control at low speeds - high speed (over 3/4 throttle) leaves something to be desired but no prop I know of meets both low end and high end values perfect.
10 par Racerstar S5048 PC 3-ostrzowe śmigło 5,0 mm Otwór montażowy do RC Multirotor FPV Racing Drone
US$8.45 US$12.68
0
Zalecenia
Komentarze (0)
Sarcoise 13/12/2018
Received in less than a week from same country warehouse, assembled in less than 2 hrs - including setup/calibration. First print OOTB was a success. The only upgrades I have installed are self printed ones, and have been happy with the results. Fan cover mod, blower mod, dial mod, extruder knob, filament guide - together these provide all you need, however you can install many more upgrades to increase print quality. Stepper smoothers, bowden tube, BL Touch, and firmware update for mesh leveling are my next upgrades. I have never used/setup a 3D printer and yet was able to get this guy going with good print quality in one evening. It does take some adjusting to get things rolling smooth but all in all this is a great package. Everything needed was included - tools, extra screws, plate scraper, even starter filament. Would def. purchase again - this is a great package.
Drukarka 3D Creality 3D® Ender-3 o rozmiarze druku 220x220x250 mm z funkcją wznowienia zasilania
US$289.00 US$499.00
0
Zalecenia
Komentarze (0)
Sarcoise 18/09/2018
Great props for my RCX 2206 motors. Provide perfect static thrust and decent top end. Lightweight, reasonably durable props. Have made more purchases of these same style propeller.
10 par GEPRC 5040 V2 5 cali 3-łopatowe śmigło przezroczystego koloru do wielowirnikowca RC do wyścigów FPV
US$10.34 US$17.98
0
Zalecenia
Komentarze (0)
Sarcoise 18/09/2018
Used these to add 5v LCD lights on my quad without straining the built in BEC for the FC. They do exactly what they were made for. Small, simple hookup diagram.
Moduł 3B UBEC Low Ripple Bluesky Mini Switch-Mode DC BEC 5V 12V 2-6 S Dostawa dla RC Drone
US$3.35 US$3.69
0
Zalecenia
Komentarze (0)
Sarcoise 18/09/2018
Used these to add DVR capability to my EV800 box goggles. Followed a tutorial on YT that make locating the pins a piece of cake. Instead of reusing one of the buttons I just mounted this device on top of the goggles and the included navigation thumbwheel works fine. I could see that component being a weak point with this setup (the thumbwheel) but if yours wears out, you can always wire up external buttons to replace it. my only complain is with the FW in that if you are watching a video and use the fast forward feature, there is no way to return to normal speed. It just stays in 2x play mode, forward or reverse. Skipping forward again makes it play at 4x, 8x then end of file. but all in all, a cheap way to add DVR capability to goggles what don't come with it.
Moduł mikro-DVR VCR DIY, Mini rejestrator wideo, obsługa nagrywania i odtwarzania na karcie SD do kamery FPV Monitora
US$25.40 US$26.39
2
Zalecenia
Komentarze (0)
Sarcoise 06/09/2018
this is my go-to FC, however take note that I have ordered this item twice and always receive the F4 v3 standard non-pro version. I prefer this version as the current sensor is the only added feature and doesn't seem to return valid results for most people. My go-to 4in1 ESC has a current sensor built in that works well.
Omnibus F4 Pro V3 Kontroler lotu Betaflight Wbudowany barometr OSD SD Blackbox dla RC Drone
US$26.49 US$32.99
0
Zalecenia
Komentarze (0)
Sarcoise 06/09/2018
I have built several quads using this ESC and have nothing but great results. Clean power thru video and FTX while powering straight from VBATT, I have added external caps to see if I notice anything extra, can't say that I do. As with any video feed, there are some breakups and flickers, but adding caps to ESC doesn't seem to be the problem. What little video flicker I do notice is from the analog signal. This is my go to 4in1 ESC. No complaints here.
30,5x30,5 mm Racerstar REV35 35A BLheli_S 3-6S 4In1 bezszczotkowy ESC z wbudowanym czujnikiem prądu, obsługujący DShot600 dla dronów RC FPV Racing
US$41.99 US$37.99
0
Zalecenia
Komentarze (0)
Sarcoise 06/09/2018
Threads are cut well, color finish is good. These are the stronger of the standoffs IMO, much thicker than others I have bought. The area around the threads is thicker than the center, giving a bit of extra protection.
Suleve ™ M3AR3 10 sztuk M3 35 mm radełkowany wspornik ze stopu aluminium, wielokolorowy
US$10.38 US$10.99
0
Zalecenia
Komentarze (0)
Sarcoise 06/09/2018
I purchased these as a low cost way to enter the hobby and have put off reviewing for some time to test. Straight to the punch - these are good goggles. They perform their function, video is clear, reception is good. For anyone who prefers box goggles or is trying to save some money and enter the hobby for a lower price - these are a great buy. I receive a constant signal when flying 200 meters or so, less if through obstructions trees/buildings. Diversity may help slightly with range (the EV800D offers this) however I don't think the slight improvement with reception vs price offers much to the new FPV pilot. (I'm cheap) Has a Fresnel like lens in front of the LCD screen which puts the point of focus 8-10" (200mm-250mm) in front of your eyes. Goggles slide apart to allow cleaning/altering/modifications etc. The Fresnel lens stays with the headstrap side and can be used as a sort of magnification device. The LCD screen half is in a nice viewing platform witch makes for easy bench testing, viewing what the camera displays without having to put on the goggles.
Eachine EV800 5 cali 800x480 Gogle FPV 5.8G 40CH Raceband Automatyczne wyszukiwanie Wbudowana bateria
US$69.29 US$74.39
0
Zalecenia
Komentarze (0)
Sarcoise 21/08/2018
Great basher blades for learning to fly or performing close in stunt attempts where blades are likely to make contact with objects. At this price, simply throw another one on if it gets damaged. I find the material is stiff enough to provide good punch out but at times can be brittle. This may be the reason I have not had to replace and motors/shafts as the blades are designed to break under a certain stress before any damage is done.
10 par Racerstar V2 5042 5x4.2x3 3 ostrze śmigła 5.0mm otwór montażowy dla RC Drone FPV Racing
US$5.97 US$9.22
0
Zalecenia
Komentarze (0)
Sarcoise 21/08/2018
I've seen these styled racerstar props so I decided to give em a try. They do seem more suited for the larger motors (2206 +) with the steeper pitch and design that is completely different from the racerstar 5042. Tapered tri blades provide lift closer to the hub while the tips provide lift at higher RPM's. I've been using for freestyle flying and they work great. One thing to note is they are made from the same material as the previous Racerstar 5042, this can either be a good thing, or bad depending on your experience with them. I find the material is stiff enough to provide good punch out but at times can be brittle. This may be the reason I have not had to replace and motors/shafts as the blades are designed to break under a certain stress before any damage is done.
10 par Racerstar S5048 PC 3-ostrzowe śmigło 5,0 mm Otwór montażowy do RC Multirotor FPV Racing Drone
US$8.45 US$12.68
0
Zalecenia
Komentarze (0)
Sarcoise 06/07/2018
Purchased these to replace standard 5mm motor shaft prop nuts. Assumed these were aluminum, however they are much heavier and must be steel. They fit and thread great, just not as light as I wanted. Will keep to use in a pinch.
10 par silników bezszczotkowych Emax MT2205 RS2205 2205 CW / CCW zamiennik nakrętki śruby do drona RC FPV Racing
US$10.38 US$10.99
0
Zalecenia
Komentarze (0)

Jesteś ekspertem, czy możesz pomóc?

Serdecznie zapraszamy do zasubskrybowania e-maila z zaproszeniem!

Jeśli się zapiszesz, zaprosimy Cię e-mailem, aby odpowiedzieć na pytania ludzi dotyczące produktów. Subskrybując Ciebie], zdobędziesz także "Pomocną odznakę "! Możesz zrezygnować z subskrypcji w dowolnym momencie na stronie ustawień prywatności.

Pomóż innym i bądź szczęśliwszy!

  • Subskrybuj

O odznakach

Odznaki są powiązane ze społecznością, a użytkownicy zdobywają odznaki, tworząc wysokiej jakości treści, wykonując misje lub uczestnicząc w specjalnych działaniach. Określeni ludzie również będą mieli własną wyłączną odznakę.
Odznaka CEO

Odznaka CEO jest własnością tylko szefa Banggood.

Wkrótce otrzymasz odznaki, które możesz zdobyć
  • ok

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • ok

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe