Wszystkie wiadomości

BG544461619 If its the upgraded one its 200 mm if its the earlier one it starts at 0 the upgraded one takes into account the width of the track makes it a lot easier to calibrate definitely go for the upgraded one. Hope that helps

2022-10-15 04:23:11 Pomocny (1)
Zatwierdź
odpowiedzi (2)

Q: Is is compable with Fonson’s mini track saw square?

zapytał BG817192157 na 2022-09-26 11:12:32

BG544461619 I only have the large rail square so I cannot tell if will fit the small square.

2022-09-27 06:20:26 Pomocny (0)
Zatwierdź
odpowiedzi (2)

BG544461619 I have honed mine with a fine diamond hone taking as little of as possible also you can buy bits at places like Screwfix or Toolstation hope that helps

2022-09-13 04:40:04 Pomocny (0)
Zatwierdź
odpowiedzi (2)

BG544461619 As far as I am aware it is only the 800 ad the 1000 I have the full set from 300 to 1000 and have never had any problems with the shorrter bar Cheers Ian

2022-08-19 07:38:16 Pomocny (0)
Zatwierdź
odpowiedzi (1)

BG544461619 the centre to centre across all three is 96mm 32mm from one to the next so your plan would not work why do you need all three when two especially eight mm dowels would be sufficient.I would reccomend the jig as its a fantastic bit of kit and to accompany it is a long jig with about twenty holes in it which accept the same guides as the dowel jig with the same 32mm centres great if you do any cabinet carcasses and you can also purchase guides from 4mm to 10mm very reasonably priced. the only downside ive found is it can take a long time for the jigs to arrive but apart from this it is a fantastic bit of kit you wont regret getting one.A good review has been done on you tube by Dennis at Hooked on Wood.

2022-07-12 10:27:38 Pomocny (1)
Zatwierdź
odpowiedzi (1)

BG544461619 Hi You would be better getting in touch with the manufacturer I would think they probably sell them as spare parts. Cheers Ian

2022-06-13 04:48:03 Pomocny (0)
Zatwierdź
odpowiedzi (2)