Wszystkie wiadomości

Q: What is the max RF Power for this bridge?

zapytał BG172101915 na 2022-01-17 11:27:44

BG321646142 Documentation indicates 100 W

2022-02-01 05:21:01 Pomocny (1)
Zatwierdź
odpowiedzi (2)

Q: Is this chip genuine FTDI or clone?

zapytał BG172101915 na 2021-02-07 10:52:48

WolfxPac how do you differentiate between them? it's open-source hardware using same USB to TTL IC.

2021-09-17 12:19:16 Pomocny (0)
Zatwierdź
odpowiedzi (2)

Q: What is the measurement frequency for this unit?

zapytał BG172101915 na 2020-02-28 12:37:22

BG555247215 Thisdevice measures earth ground resistance, not the frequency

2020-11-05 01:14:14 Pomocny (0)
Zatwierdź
odpowiedzi (2)

Q: What is the diameter of

zapytał rbusque na 2018-03-28 07:10:50

PampaWak About8mm. Please permit me 1-3cm of tolerance because of manual measure.

2020-05-05 12:07:28 Pomocny (0)
Zatwierdź
odpowiedzi (1)

PampaWak Idon't know exactly, but it's about 8/10mm. Sorry for this delay, but I didn't know about this part of the website!

2019-10-18 04:55:37 Pomocny (0)
Zatwierdź
odpowiedzi (1)

Q: What is the diameter of the ceramic tube?

zapytał rbusque na 2018-03-28 07:14:18

Sandu max12.4mm, min 10.4 mm - is eliptic, not round

2019-09-17 09:25:32 Pomocny (0)
Zatwierdź
odpowiedzi (1)

Q: nela pode por 2 filamento ao mesmo tempo ?

zapytał ????????? na 2019-08-11 07:20:32

rbusque Natively,it can only handle one filament at a time. This being said, my impression is that these are highly modifiable.

2019-08-12 07:53:23 Pomocny (0)
Zatwierdź
odpowiedzi (4)

rbusque Minedid not have magnetic platform. When I researched the resume function for this, though possible, it was clear there would always be some artifact in the print...I opted to not enable it. Printing can be done directly from the micro SD. Extruder is nothing fancy. I ended up installing a bed sensor for levelling...made a huge difference in repeatability.

2019-08-12 07:50:56 Pomocny (0)
Zatwierdź
odpowiedzi (4)