Wszystkie wiadomości

blue_z So far from my experience, this NVR's 'search for cameras' will not detect my GD-SC02 updated with firmwares 3.2.0.1118 and 3.2.8.0121.

2018-02-16 06:39:53 Pomocny (0)
Zatwierdź
odpowiedzi (3)

blue_z Screw size depends on the drive's form factor. 3.5" drives use one size, 6-32, while 2.5" drives use a different size, M3.

2018-02-16 06:33:17 Pomocny (0)
Zatwierdź
odpowiedzi (1)

Q: what size hard drive does this need?

zapytał willeymunda na 2018-02-09 05:34:52

blue_z "Size" could refer to the drive capacity or the form factor. What are you asking?

2018-02-16 06:28:55 Pomocny (0)
Zatwierdź
odpowiedzi (3)

blue_z The cameras and this NVR should be in the same IPv4 subnet. Use a wireless router or access point to connect wireless cameras to the Ethernet LAN.

2017-12-20 05:17:12 Pomocny (0)
Zatwierdź
odpowiedzi (1)

blue_z The default configuration screen supports eight cameras (aka channels), but that can be increased to twelve if you're not using 1080p cameras and the network and HDD recording bandwidth is sufficient.

2017-12-20 05:04:29 Pomocny (0)
Zatwierdź
odpowiedzi (2)

Q: Are ONVIF and rstp available on this camera?

zapytał ambuddy na 2017-11-10 03:03:52

blue_z Apparently new versions of the SC02 have ONVIF support, but earlier versions are questionable. My SC02 camera has been updated with version 3.2.0.1118 firmware, but the GD-NR01 recorder does not find it while searching.

2017-12-19 04:57:18 Pomocny (0)
Zatwierdź
odpowiedzi (4)

blue_z It does not have batteries, so you have to connect the USB cable for power.

2017-12-19 04:45:45 Pomocny (0)
Zatwierdź
odpowiedzi (2)

blue_z You can watch a live stream of the cameras from the NVR as it records. There's a choice of four layouts to see one or up to eight camera streams. The delay is less than a second.

2017-12-19 04:14:26 Pomocny (1)
Zatwierdź
odpowiedzi (2)