Najlepsze oferty na Zestaw mikrofonowy BM800,Gardziel dyszy,Czujnik prądu

gshingles 24/11/2020

Pretty good. Not very much gain with the included USB adaptor and cable, but sounds good powered by phantom power on a mixer. The arm is a bit "how ya doin" but adequate for the job.

Zestaw mikrofonu kondensatorowego BM800 Pro do studia z zawieszeniem na statywie z ramieniem nożycowym i filtrami

38,35€ 43,41€

0

Komentarze (0)

gshingles 18/04/2019

Used on the Anet A6 which comes with a 40mm throat. This made the nozzle a few mm too high even with the build plate fully up, but a careful bend down of the z-switch lever arm fixed that. It puts the cooling duct outlet closer to the nozzle, but that hasn't caused any issues so far. Have used the 35mm throat without any problem since I replaced the broken 40mm one.

5szt. 1,75 mm GARDŁO M6 35 MM dla drukarki 3D Extruder RepRap

13,84€ 14,75€

1

Komentarze (0)

gshingles They are meant to be about the same thing, but OU2 is buffered through an op amp. Found this vid with reasonably good demo of the board: https://youtu.be/alAly-oTha0

jacquev6 11/11/2017

Attached pictures show poor soldering job on the 50A leads of the sensor. Passing 50A in these joints would melt them. After re-soldering, everything works as expected. Good product overall.

CJMCU-758 ACS758LCB-050B-PFF-T Linear Czujnik prądu Hall Current Module

12,78€ 13,83€

5

Komentarze (2)

2.4-10.5GHz UWB Kierunkowa Antena szerokopasmowa o wysokiej wydajności TEM z szerokopasmową anteną transmisyjną 2,4G

10,60€ 16,60€

Q: Do you have an antenna plot? Radiation pattern at say 2.4 and 5 GHz?

zapytał gshingles na 2019-06-07 07:30:12

Numen it can work with 2.4-10.5GHz

2019-06-11 10:18:54 Pomocny

Zatwierdź

odpowiedzi (1)

gshingles 11/03/2019

Haven't tested the xtal function, but tested the 1kHz against my DSO150 signal generator ok. Assembly is not tricky. I left the paper on the acrylic and carefully cut out a window for the display, will see how long that lasts.

Geekcreit® DIY Tester częstotliwości 1Hz-50MHz Licznik kryształów z zestawem obudowy

11,66€ 11,98€

0

Komentarze (0)

gshingles 02/05/2019

Works as expected.

Excellway® 10/20/30/40/50A 12V 24V Auto Panel słoneczny Regulator ładowania baterii ładowarka USB LCD

13,78€ 14,75€

0

Komentarze (0)

gshingles 01/03/2019

Lead insertion works fine on this one. Letters and numbers all match on each side. Well made.

Płytka prototypowa Płytka do krojenia chleba z 400 otworami + 65 szt. Kabel skokowy do deski do krojenia chleba

5,80€ 5,53€

0

Komentarze (0)

gshingles 01/03/2019

Downloading the image in the description to get immediate satisfaction. Haven't tried the case, the screen fit over the stacked acrylic design I bought locally.

Geekcreit® 3,5-calowy ekran dotykowy TFT LCD + etui ochronne + radiator + zestaw pióra dotykowego do Raspberry Pi 3/2 / Model

22,36€ 23,98€

0

Komentarze (0)

gshingles 01/03/2019

Good shave and fits my razor.

GFLV® 4szt. 5-warstwowe ostrza Maszynki do golenia z golarką do golenia

4,60€ 18,36€

0

Komentarze (0)

gshingles 06/01/2019

Works as advertised, if you give it enough juice! I thought mine was broken, brief temp drop then reboot loop with around 1.5A. The quick temperature reading drop appears to be normal though, more amps sorted out the reboot >3A Not a fan of the included conical tip, prefer chisel but it does the job.

Cyfrowa programowalna stacja lutownicza LCD Wbudowane czujniki przyspieszenia z wbudowanym interfejsem STM32 Chip DC 5525

51,30€ 64,17€

0

Komentarze (0)

gshingles 27/06/2018

They seem to do what they claim to. The temperature measurement moves slowly but I don't think that's too much of a problem.

Cyfrowy termometr DC 000 Higrometr Stacja pogodowa Budzik Colorful Kalendarz LCD

14,91€ 15,67€

0

Komentarze (0)

Witamy w Banggood,

Pozwalasz:

Wszystkie wiadomości

Jesteś ekspertem, czy możesz pomóc?

O odznakach

About Badges

Helpful Badges

Are you ready to help?