Wszystkie wiadomości

Aurum@Alexandre It\'s been a while, but I believe I\'ve changed a resistor in serial to the potentiometer to allow a voltage range less than 5V. In other words changed the ratio of the voltage divider between Vout and the feedback line (potentiometer variable pin).

Aurum 2019-11-15 11:09:26
1
Komentarze (2)
Aurum 2019-11-15 11:09:26
1
Zalecenia
Komentarze (2)

Najlepsi recenzenci, których możesz lubić:

Q: 1. what is the clamping range? 2. can I attach regular drill bits?

zapytał MannySaunders na 2020-10-21 11:48:48

Aurum The range is minimal as it's meant to lock on the rectangular end part of the drill taps. You can put drills in it but why would you? It's not a chuck. Use a proper tool for that.

2020-10-21 02:40:33 Pomocny (0)
Zatwierdź
odpowiedzi (1)
Aurum 2020-09-15 03:55:54
0
Zalecenia
Komentarze (0)

Najlepsi recenzenci, których możesz lubić:

Aurum 2020-07-27 15:46:31
0
Zalecenia
Komentarze (0)

Najlepsi recenzenci, których możesz lubić:

Aurum 2020-07-27 15:46:31
0
Zalecenia
Komentarze (0)

Najlepsi recenzenci, których możesz lubić:

Q: Where can I find english data sheet?

zapytał giuliano na 2020-07-24 02:39:17

Aurum Not sure it exists nor you really need one unless you wanna write a driver for the controller chip. Just make a search on google for "arduino ILI9341" or the chip your display uses and you'll find sufficient information.

2020-07-24 03:36:06 Pomocny (1)
Zatwierdź
odpowiedzi (2)

Q: I have the 2.4" unit 240x320. Should the VCC be 5v or 3.3v?

zapytał BG573543554 na 2020-07-07 11:19:09

Aurum The ILI9341 chip was designed for 1.65V ~ 3.3V operation. There is a regulator chip onboard for power, I'm not sure about the data lines though, so safest is to drive it by 3.3V.

2020-07-08 04:15:26 Pomocny (1)
Zatwierdź
odpowiedzi (2)