ThompTech
Q: Which polarization direction the cleaver antenna has on this helmet?
zapytał shark3v na 2020-03-09 09:46:34
Q: This 4in*****a esc work with F3 Flight controller Acro 6DOF.?
zapytał binh ha na 2020-02-28 10:21:58
ThompTech Yes it will. This esc will work with essentially every f3 or later board.
2020-03-12 10:50:51 Pomocny (0)Q: Previously, when the green LED lights up. Red is on now. Battery after charging. What happened?
zapytał kalashnikmaxik na 2020-02-05 01:03:34
ThompTech The red light comes on when the unit is charging. The green light comes on when the unit is finished charging. This may indicate an issue with the battery or charging system.If the wall charger isn't working try the USB charger. If neither works that would point to your goggles having the issue. If one charger works and the other does not then its likely the charger.
2020-02-05 07:01:35 Pomocny (1)
ThompTech 1. Pull is same as thrust/lift in this case and refers to the grams of thrust produced at a given volt/amp. 2. This motor can run on a 3S 11.1v lipo or a 4S 14.8v lipo battery. The the 14.8v draws more amperage @ 27A and provides more pull/thrust. Hope that clears it up.
2020-01-08 04:57:41 Pomocny (0)Q: what can be the minimum measured voltage for 1 cell 3V / 2.5V?
zapytał AndrzejG22 na 2019-05-14 11:45:17
ThompTech Don't go below 3.2 volts or the charger will likely give a low voltage error and refuse to charge the cell. Also do not charge each cell beyond 4.2 volts or you risk fire and or damage to battery life.
2020-01-07 09:20:37 Pomocny (1)
thompson49022 If coil is not working then replacement would be based on if you are still in warranty. Check your motor manufacturer's warranty and if you are within its coverage time submit a claim and they will take care of it. I would start with warranty check and if its still in warranty get the free replacement. Otherwise, try epoxy applied with a tooth pick. Try to keep the loose coil in its original shape as much as possible then use the epoxy to hold it to the parent coil. Cheers!!
2020-01-07 09:03:04 Pomocny (0)
thompson49022 This particular model does NOT use iBus. It does work with SBUS, PPM, DSM and PWM signals.
2020-01-07 09:00:00 Pomocny (0)Serdecznie zapraszamy do zasubskrybowania e-maila z zaproszeniem!
Jeśli się zapiszesz, zaprosimy Cię e-mailem, aby odpowiedzieć na pytania ludzi dotyczące produktów. Subskrybując Ciebie], zdobędziesz także "Pomocną odznakę "! Możesz zrezygnować z subskrypcji w dowolnym momencie na stronie ustawień prywatności.
Pomóż innym i bądź szczęśliwszy!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
ThompTech RHP. Right Hand polarization is the default for most systems. Left hand is used when you are near a person using RHP (such as a race event) to help with interference as RHP and LHP interfere with each other less than when both pilots use RHP..
2020-03-12 10:54:55 Pomocny (2)