CM703 2.4G 7CH RC Odbiornik z wyjściem PPM dla RC Drony
Część recenzji została przetłumaczona automatycznie.
Kupiłem go miesiąc temu, ale do tej pory nie jestem w stanie go związać, nie polecam
Top i działa świetnie na moim dx5e
receive the item, but not yet tested
/Dotarł bezpiecznie.
To fantastyczne, szybka dostawa, dziękuję ci Banggood
Had problems binding to my DX6i DSMX transmitter but after watch this video (www.youtube.com/watch?v=Wv-6i1Vsop4) and soldering the unsoldered joints I found it easy to bind and works with no problems. Reccon need to do a bit of quality control before allowing these devices to leave the factory. I've attached a photo to show the unsoldered joints.
To mój drugi RX. Kiedy zamawiam pierwszy, to tylko dla lotów testujących LOS. Ale byłem zaskoczony, jak dobry jest ten. To naprawdę doskonała alternatywa dla tych drogich Spectrum Rx. Daje dobry zasięg i nie miałem z tym żadnych problemów. Jedyne negatywne, jakie widzę, to to, że nie wspomina o polaryzacji ani sygnałach przy połączeniu z serwo.
Pros: Extremely sensitive, high range, sturdy, very light, does not heat. Great in quick response. Cons: Box is fragile and the antennas could be 1/3 larger
Miałem to wcześniej... I muszę przyznać, że te dają ci imponujący zasięg i połączenie. Najlepsza alternatywa dla odbiorników Spectrum, z niesamowitym zasięgiem.
This is the best receiver if you fly spektrum! I love the two long antenna! Super easy to get them apart and separated by 90 degrees. I love the ppm output too! Super easy to connect to a flight controller. Also, it has a satellite port for flying larger gas or nitro models. Pro tip: placing the receiver in bind mode, THEN REMOVING THE BIND PLUG BEFORE BINDING THE TRANSMITTER, will make all of the channels move to the bind position when signal is lost. Very useful for getting a flight controller to go into RTL mode. Normally, it moves the throttle to the bind position and freezes all of the other channels when signal is lost.