Podgrzewana podkładka Podgrzewana podkładka silikonowa o mocy 750W
Część recenzji została przetłumaczona automatycznie.
Jeden z najlepszych modów do mojej drukarki działa świetnie
Very good product, It is working perfectly. Just keep in mind that you can not make a hole through it. It may break the lines. It heats up the bed of my printer in 30 sec from ambient to 90C. You need wiring, a solid state relay is needed. You can connect wires of heater of old heating bed (normally it is 12 or 24 v) as the control signal to solid state relay. Check the voltage of the signal before ordering the solid state relay. they should match. I highly recommend it!
Goot Product. My HotBed heat now very fast, and not only to 70°C like with the 12V Version, no 110°C is no Problem Goot Solution Goot Price Fast Delivery
as described, very good
packed very good and arrived in very good condition. I'll give more feedback after some time of use
the only drawback with this item was that the thermistor was shorted out where they had soldered the pins to the wire. measure the resistance in the thermistor before mounting it, as this item has no quality control! it uses a 100k thermistor. it bring my bed to 120°C in a few minutes!!
Niestety, ogrzewanie w dostawie ucierpiało bardzo, opakowanie było bardzo złe, rogi są wygięte i klej nie działa już na rogatkach, tutaj musisz pracować sam. Opakowanie było zbyt cienkie, a zatem stabilność nie była gwarantowana.