3 szt. 1M Rura Bowden z PTFE do drukarki 3D Reprap z filamentem 1.75mm
Część recenzji została przetłumaczona automatycznie.
Parfait pour déporter le moteur d'un extrudeur.
correspond au déscriptif
the PTFE tube itself is fine, comes with 2 push fit ends aprox m10 thread. so glad I also ordered some m5 push ends. where i was disappointed was the packing, it comes coiled to a diameter of aprox 100mm which is bad enough, but then the ends were wrapped through the coil , causing the whole length to take a spiral form, the worst of which suspending with a weight on the end for a day or 2 managed to remove. so usable but a bit kinky
Zgodnie ze specyfikacją
Doskonała jakość, otrzymałem to, czego się spodziewałem, jednak myślę, że dla osoby takiej jak ja, która ma tylko 2 drukarki jest to dużo części zamiennych, ale nigdy nie jest to za dużo. Excelente calidad, recibi lo que esperaba, sin embargo que una persona como como 2 impresoras es mucho repuesto, pero nunca esta esta demas.
Zbyt długo, ale w porządku
very Good
Szybka dostawa
Zgodnie z opisem...
Mam, ale nie używaj go jeszcze.