Franck_HELIE
Q: where to wire S.Port? (I wire my SBUS to RX6). I’m using R-XSR receiver
zapytał Anrein na 2018-07-01 11:52:21
Franck_HELIE With betaflight, if you use sbus connected to rx6, you probably don't need ppm 1 pin. In this case, you can use softseral_tx on ppm 1. To do that, in btf cli, write following commands : activate Telemetry & softserial in btf configuration resource PPM 1 none resource ESCSERIAL 1 none resource PWM 1 none save resource SERIAL_TX 11 B08 save set tlm_inverted = OFF set tlm_halfduplex = ON save that's all, you will now be able to receive telemetry on your taranis ... (tested on board flashed with betaflight omnibusf4sd firmware 3.5.4 & X8R rx)
2019-01-17 03:57:32 Pomocny (1)
Serdecznie zapraszamy do zasubskrybowania e-maila z zaproszeniem!
Jeśli się zapiszesz, zaprosimy Cię e-mailem, aby odpowiedzieć na pytania ludzi dotyczące produktów. Subskrybując Ciebie], zdobędziesz także "Pomocną odznakę "! Możesz zrezygnować z subskrypcji w dowolnym momencie na stronie ustawień prywatności.
Pomóż innym i bądź szczęśliwszy!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
