Wszystkie wiadomości

svilponis Press REL button to zero DC amps reading before you start to measure. This should remove any constant offset, for following measurement. This multimeter is not meant for non contact measurement of very low currents, so do not expect, that you can get precise results for currents below 1 A.

2020-01-16 09:29:50 Pomocny (1)
Zatwierdź
odpowiedzi (4)

svilponis Press REL button to zero DC amps reading before you start to measure. This should remove any constant offset, for following measurement.This multimeter is not meant for non contact measurement of very low currents, so do not expect, that you can get precise results for currents below 1 A.

2020-01-16 09:23:22 Pomocny (5)
Zatwierdź
odpowiedzi (5)

Q: no indication of pipe size anywhere, not in any pictures

zapytał droptail na 2019-07-13 03:45:28

svilponis 1/4 inch female

2020-01-06 02:09:51 Pomocny (0)
Zatwierdź
odpowiedzi (1)

svilponis I used my Ampermeter and measured the current. The antual current is totally different than the charger is showing.

svilponis 19/11/2019
3
Komentarze (2)

Q: can it measure low dc current like 20 mAmp ?

zapytał SimoTerror na 2019-11-12 04:20:52

svilponis It has resolution of 0.01A (10 mA), so it can show you value 20 mA, but it is not precise at such low currents (precision level at such small currents is ca ±0,35A.

2019-11-15 09:42:01 Pomocny (5)
Zatwierdź
odpowiedzi (6)

Q: can you swap between MPH and KMH ?

zapytał Flash na 2018-07-15 01:30:03

svilponis yes

2019-10-17 06:19:12 Pomocny (0)
Zatwierdź
odpowiedzi (1)