odpowiedzi

Q: What mode is it on?

zapytał Bob.Ward. na 2023-11-27 22:01:37

Laurie It is mode 2, but since it is only two channel, even a mode 1 flyer like myself can fly it easily. Also, if you have a multi protocol radio, the protocol is supported, so now I fly mine in mode 1 with my transmitter. It is a much better experience flying it with a multi protocol radio, but it is quite acceptable with the supplied transmitter.

Pomocny (0)
Zatwierdź
odpowiedzi (1)

Laurie I do not have this helicopter, but there is a link to the manual on the product page above. On the page of the manual titled Introduction to Transmitter Function it says there is a button on the transmitter which will change the mode if you press it when powering up the transmitter. I do have the Eachine E129, and that is exactly the way the mode change works on that one. So whether you order the Mode 1 or the Mode 2 version, you can always switch to the other mode. The only difference between them is which mode is activated by default when you power up.

Pomocny (1)
Zatwierdź
odpowiedzi (2)

Q: Peut on régler le pas sur la radio et l'expo ?

zapytał riky78990 na 2022-06-02 04:56:32

Laurie On peut régler le pas en trois étapes, mais il n'y a pas d'expo. Yes, you can adjust the rates in 3 steps, but there is no expo.

Pomocny (0)
Zatwierdź
odpowiedzi (3)

Laurie I do not have this helicopter, but there is a link to the manual on the product page above. On the page of the manual titled "Introduction to Transmitter Function" it says there is a button on the transmitter which will change the mode if you press it when powering up the transmitter. I do have the Eachine E129, and that is exactly the way the mode change works on that one. So whether you order the Mode 1 or the Mode 2 version, you can always switch to the other mode. The only difference between them is which mode is activated by default when you power up.

Pomocny (6)
Zatwierdź
odpowiedzi (6)

Q: can you take pictures of the inside?

zapytał wahmhofftech na 2020-09-02 12:19:17

Laurie Also Andrew Newton has done a Youtube review of it that shows what is inside, and shows it flying.

Pomocny (2)
Zatwierdź
odpowiedzi (5)

Q: Does it include the shrink wrap?

zapytał BG544757515 na 2021-08-17 23:48:18

Laurie If you mean the heat shrink to attach the carbon fibre pushrods to the wire connectors that fit the control horns, yes it is included. I recommend you put a little glue inside the heat shrink before shrinking just to make sure the wire can't move within the heat shrink. I have had that happen with other models when I relied on the heat shrink alone.

Pomocny (0)
Zatwierdź
odpowiedzi (2)