Część recenzji została przetłumaczona automatycznie.
the rx and tx are marked the wrong way around in rc in the pick here. Go to http://www.olliw.eu/storm32bgc-wiki/Getting_Started for correct pins for this v1.3 board. My led next to reset and boot did not work, but i was able to flash it still with v0.7 firmwear. i also had to check the perform full chip erase box in the o323BGCTool_v080 to get it to flash. i flashed with one of these http://www.banggood.com/FT232RL-FTDI-USB-To-TTL-Serial-Converter-Adapter-Module-For-Arduino-p-917226.html then used the o323BGCTool_v070 for the Configuration & Calibration though the usb on the board
Hallo Das Gehäuse passt nicht! Alle Öffnungen müssen nachgearbeitet werden. Angeschlossen an 12 Volt und schon die ersten Rauchzeichen, Mosfet ist abgebrannt. Spannungswandler defekt. Zu wenig Pins! Banggood stellt sich quer mir ein neues zu schicken, Video und Bilder sind zugeschickt. Hinhalten und wieder fragen nach Videos.