Płyta BMS do ładowania ochrony baterii 18650 Li-ion 2S 3A
Część recenzji została przetłumaczona automatycznie.
A simple little protection board for low current (3A or less draw) systems using 2 series lithium cells. The type / size of cell is not important but the chemistry, must be lithium. The Negative ( -) end of the first cell is connected to the PCB terminal marked B- The connections between the (+) positive end of the first cell and the (-) Negative end of the second cell is connected to the PCB terminal marked BM (battery middle?) The (+) Positive end of the second cell is connected to the PCB terminal marked B+ The connection to the load / charge is made to the terminals marked P+ (7.5V nominal) and P- (GND Negative) Operation is simple. If either of the 2 series cells exceeds the upper voltage limit or drops below the lower voltage limit, the load / charge connection disconnects. The load / charge connection reconnects when the voltages are normal again. This may be the basis of a simple charge limiting circuit and over discharge protection circuit. The board is well made and works as it should. I hope this clears up some of the questions raised.
Nabíjací a ochranný obvod pre 2ks spojené Li ion batérie 18650 2S 7,4 V. Balenie po 5 ks.
Szybko przybyło
Bardzo dobry polecam 🤝🏿
Kupiony w celu ochrony zewnętrznych baterii jonowych dla zewnętrznego modułu r9m. Podkładki do lutowania są delikatne. Przy 385° odłączają się i poruszają.
Szybka dostawa. Działa dobrze
good quality, it's working, very small dimensions
przybył bardzo szybko, ale nie próbuję tego, ale wygląda dobrze, gdy spróbuję to skomentuję więcej
nice and small
O. K. Bardzo dobrze.