Dostawa do United Kingdom , USD
Najlepsza pozytywna recenzja dla %s na Banggood, Kupuj najlepiej %s w najniższej cenie na Banggood. Przed zakupem przejrzyj najbardziej pomocne pozytywne recenzje dotyczące %s., zabawki rc, sport rozrywkowy, moda, popularna elektronika
blitzen 16/01/2019
This combo board has a 4 channel receiver for a motor, rudder, elevator and aileron. There are 6 outputs. Brushed motor solder pads. Brushless ESC solder pads. 2 servos (rudder and elevator). 2 connectors for the opposing ailerons. The receiver auto binds after 10 seconds. Setup a new model with FrSky D8 on the TX and set to bind. Then power the receiver. Wait for steady light, then power off. No mention current ratings. The speed control was able to handle a 0720 17000KV core-less motor. The largest LiPo battery tested was a 3.7V 250 mAh 35C. Alternately, a 1S brushless motor and a tiny ESC can be used. The onboard linear servos are relatively quick and pull 35g. The control horn, pushrod and servo should extend along a straight line. That way the push rod transfers the most movement (7mm) and results in enough control surface sweep. 2 tiny (1m) onboard JST connectors replaces an aileron wiring harness that wires a pair of micro linear servos to operate oppositely (which rolls the aircraft). Adding a pair of digital servos will cost about $20. There is no telemetry but the plane will drop if the signal is lost. The receiver doesn’t appear to have a low voltage cutoff so setting a timer is a good idea. Initially, the receiver seems a little jittery with nothing connected. After setting up the model, it calmed down considerably. Configuring the receiver is a function of a programmable transmitter. I’ve been using the TaranisQ X7.
24
Komentarze (4)
Zatwierdź
  • martak Where to buy jst connectors and serva?

    Odpowiadać 25/12/2019
  • tubetriode bind the rx with Taranis xd9 is ok, but Throttle channel becomes Elevator and Rudder becomes Ail, do you know how to fix it? Thank you!

    Odpowiadać 14/07/2020
  • Tim you can change the channel assignment in your Taranis

    Odpowiadać 09/01/2021
  • BG415583714 I have been considering a Flysky fs-i6 transmitter. Is this receiver compatible?

    Odpowiadać 13/02/2021
Badanie zadowolenia

Pobierz aplikację, aby uzyskać ekskluzywny kupon <b> 10% zniżki </b>