Everything works as advertised however the modification implemented for the I2C compass interface is very poorly done. This modification blocks the use of the rest of the pins on the connector. Had the wires simply been soldered on facing the opposite direction this could have been minimised. A more practical solution would have been to solder the pin header in place and the connect the pull up resistors to these pins allowing standard dupont connectors to be used.

Everything works as advertised however the modification implemented for the I2C compass interface is very poorly done. This modification blocks the use of the rest of the pins on the connector. Had the wires simply been soldered on facing the opposite direction this could have been minimised. A more practical solution would have been to solder the pin header in place and the connect the pull up resistors to these pins allowing standard dupont connectors to be used.

Everything works as advertised however the modification implemented for the I2C compass interface is very poorly done. This modification blocks the use of the rest of the pins on the connector. Had the wires simply been soldered on facing the opposite direction this could have been minimised. A more practical solution would have been to solder the pin header in place and the connect the pull up resistors to these pins allowing standard dupont connectors to be used.

Soldering needed, and would like a much more indepth manual

Soldering needed, and would like a much more indepth manual

Soldering needed, and would like a much more indepth manual