Opinie klientów

5 z5
Napisać recenzję
  • Wszystkie recenzje(13)
  • Obrazy
  • Wideo(0)
  • All Star
    • All Star(13)
    • 5 Star(13)
    • 4 Star(0)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sortuj według:
Do podglądu
  • Do podglądu
  • Najbardziej pomocny
  • Najnowszy
  • July-22 2019 16:36:29

    Excellent for Small Solar Projects. Continuous Out Put Voltage, CC , CV with Battery Low Voltage Protection. Wish I could find a 20A or 30A unit performing the same tasks. These units perform some what as a Poor Mans MPPT. You do realize a bit of Current Gain via over Voltage Buck Down to Working Voltage ( Set Out Put Voltage ) . When Source Voltage is less then Working Voltage ( Set Out Put Voltage ) your able to obtain limited Charging current . Better then NOTHING, eaaaa? Again Looking

    Komentarze
  • June-04 2020 11:11:35

    Je suis énervé car je l'ai reçu hier et je viens juste de le tester et la premier branchement led rouge en default ! J'ai attendu un long moment pour finir mon projet et la impossible de le finir ! Envoyez moi un autre svp car mon achat ne fonctionne pas ! La video

    Komentarze
  • January-16 2020 00:33:28

    Worked well. Screw Terminals are very small and will only accept small wires. I would advise extra cooling when load is greater than 65 watts Typical overall efficiency was around 95% for inputs between 11 and 26 volts and output between 12 and 15 volts, with load from 1 to 4.5 amps.

    Komentarze
  • August-31 2020 17:46:17

    very fast delivery, well made board and makes designing and producing your own not worth while. best is just buy the build product.

    Komentarze
  • June-22 2020 08:41:54

    to be tested now

    Komentarze
  • June-19 2020 15:34:19

    nice

    Komentarze
  • December-10 2019 01:17:13

    Buon prodotto e buona piattoforma molto conveniente

    Komentarze
  • October-21 2019 11:06:05

    Really like this little board. I am impressed with the stability of the output. I also like that despite there being no back feed protection on the output side, there does not appear to be any appreciable voltage leak back into the board. It would be really good if the board was also offered with the three potentiometers on fly leads so the board can be mounted in a project enclosure with the pots adjustable remotely.

    Komentarze
  • August-04 2019 08:34:23

    Nice build quality. Output voltage is easy to set. Simply use a multimeter on the output and adjust the potentiometer. Over current is not that simple: I needed to drive a load and measure the current. Lucky me, my electronic load did that for me. Other devices allow to short the output with a multimeter. Under voltage input is easy again, simply set the voltage you want on the input and adjust the potentiometer again. All in all, a nice device and very efficient according to Julian Ilett videos.

    Komentarze
  • October-27 2019 13:49:37

    My favourite converter!

    Komentarze
Show:

    Go to page

    Go
    recommendation for you