BG133639481 Exact same issue here… not good at all. Did you ever get a resolution?
Odpowiadać 10/02/2022rupert Hi,I had the same problem and after some thought placed thin shims (1mm) between the red T piece and the sliding bar and then tightened the cross head screws ensuring the slider was square to the beam, though if its slightly out I doubt it would have an appreciable effect. It all works now as it should do. Given that I won't ever be dismantling the head piece now that its set this seemed the best option preferable to removing some metal. Hope this helps.
Odpowiadać 11/02/2022rupert HiI had the same problem and after some thought inserted thin shims (about 1mm) between the slider and the T head, checked for the slider for square with the beam and then tightened the cross head screws. As I won't have any need to dismantle these pieces again it seems a good fix -all is working fine now. Hope this helps.
Odpowiadać 11/02/2022BG212174311 Sameissue here.. the support offers only some minor discount - not satisfactory. I'm think of using my router with HSS spiral bit to mill of the 1 mil of material, but not yet sure how get it squared enough.
Odpowiadać 13/02/2022Nasza firma | Skontaktuj się z nami | Płatność i wysyłka | Programy partnerskie |
---|---|---|---|