Opinie klientów

Napisać recenzję
  • Wszystkie recenzje(235)
  • Obrazy
  • Wideo(0)
  • Wszystkie gwiazdy
    • Wszystkie gwiazdy(235)
    • 5 Gwiazda(226)
    • 4 Gwiazda(6)
    • 3 Gwiazda(2)
    • 2 Gwiazda(0)
    • 1 Gwiazda(1)
Sortuj według:
Do podglądu
  • Do podglądu
  • Najbardziej pomocny
  • Najnowszy
Recenzje tylko z Twojego kraju (Poland)
|
Pokaż oryginał

Część recenzji została przetłumaczona automatycznie.

  • 10/11/2016

    Works as specified if you stay in the limits. Just a little warning: during my tests, I lowered the input voltage and under 3.5V, the circuit doesn't cut but becomes crazy and the output (that was set to 15V with the pot.) jumps to 40V with no load. With a 2k resistor at the output, it only goes to 30V. Of course, this is under the specified minimum voltage, but for solar applications, how can you guarantee that the input voltage will not be there? So when it says "Module Suitable For Solar Panel" I'm suspicious. If you really want to use it like that, you could add a small circuit between the solar panels and the converter to cut it if the voltage drops under the minimum 3.8V or clamp the output with a zener (there's no voltage rating on the output capacitor so that kind of overvoltage could damage it if it is not designed to handle 40V) Also the problem with that kind of circuit is that if you try to extract too much current from a solar cell, its voltage drops, but then the converter will try to get even more current to keep it's output and the input voltage drops even more... So you also have to add a circuit that limits the output current when the input voltage drops. Conclusion: good circuit if you use it properly but not really appropriate for solar panels despite what it says in the title.

    Komentarze
    Pokaż oryginał
  • 27/01/2021

    Will bu używany w przyszłości ze starymi zasilaczami PC do napięć zmiennych. Przetestowałem go zasilaczem i zmierzyłem napięcie wyjściowe. Wejściówka wynosiła 7.2 Voltów. Użyłem mocy wyjściowej powyżej 25 V do 1,5 Volt. Trymer do napięcia wyjściowego jest niezwykle czuły (10 potencjał obrotów), dzięki czemu można łatwo ustawić dokładne napięcie. Napięcie wejściowe powinno wynosić 5 Volt lub wyższe dla stabilnej wyjścia.

    Komentarze
    Pokaż oryginał
  • 27/09/2020

    To takie miłe

    Komentarze
    Pokaż oryginał
  • 19/02/2017

    I ordered three of these modules. I had never used them before, so I hooked them up to a basic adjustable power supply and measured the output while I made adjustments to the trimpot. I was having problems with the output voltage on the first one I tested, where it wouldn't go below 9.5V, even with a 5V input (I needed 3.3V). The step-up still seemed to work fine. I tried to figure out which component failed, but I never did. I even removed the trimpot for testing and resoldered a couple of surface mount resistors. I tested the second one, and it worked fine. I tested the third one, and it worked fine, but while I was adjusting the trimpot, I encountered the same problem and it jumped up to 9.5 V. I think this was probably due to an error on my part. I think that my alligator clip probably slipped and shorted something out. This also led me to believe that I probably killed the first one in the same manner. My advice is to be very careful when using this module, and to solder wires in place before testing. In my case, I feel that the error was on my part, and I will be ordering some more in the future, since they are inexpensive. Also, the circuit boards on all of mine were misprinted as part DSN600AUD instead of DSN6000AUD. Other than that, they are identical to the one in the picture.

    Komentarze
    Pokaż oryginał
  • brocak
    CZ
    02/12/2020

    Krok w dół DC do prądu stałego. Działa dobrze w przypadku małych ładunków, takich jak wentylatory, małe silniki prądu stałego lub inne urządzenia elektroniczne. Podoba mi się w moich projektach DIY.

    Komentarze
    Pokaż oryginał
  • 25/08/2018

    With a 12V power supply I achieve 1.75V to 47.5V output range, pretty good for the size and can easily be incorporeted inside any electronic project

    Komentarze
    Pokaż oryginał
  • 21/06/2017

    Device arrived set to 20V output. Left turn Driving a small 19V load from a USB power bank is no problem. If a more powerful source is used and the load uses more power, the temperature can rise quickly. Keep an eye on the power throughput.

    Komentarze
    Pokaż oryginał
  • 18/04/2017

    Converters work as described. Good price.

    Komentarze
    Pokaż oryginał
  • 27/12/2016

    All worked normally.

    Komentarze
    Pokaż oryginał
  • 19/06/2019

    They work great, I was impressed by the resolution of the trimpot and consistency of the voltage output. They have a wide range of input and output voltages and the current is enough for many applications.

    Komentarze (1)
    Pokaż oryginał
Show:

    Całkowity 0 stron

    Idź do strony

    Możesz być zainteresowany

    recommendation for you
    • US$6.99
    • US$4.99
    • US$6.99
    • US$9.99
    • US$3.14
    • US$8.99
    • US$16.09
    • US$7.99
    • US$4.59
    • US$11.49
    • US$32.99
    • US$8.59
    • US$6.99
    • US$9.23
    • US$120.74
    • US$5.99
    • US$30.99
    • US$21.93