Część recenzji została przetłumaczona automatycznie.
Prodotto funzionante e ottimo. Utilizzato per gadget , vedi foto allegate.
Przybył w dobrym stanie.
Solder the provided wire to the speaker then plug into the on-board socket. Apply 5V then press red record button and hold as you record your voice or other sound with the on-board electret microphone. Two choices to play back: PlayE button plays the recorded sound length up to ten seconds with one momentary push or PlayL only plays back from the start of the recording and only as long as button is held down. Sound is transferred to on-chip memory so when power is lost and reapplied, the recorded sound is still able to be played. Small LED blinks once giving an indication of record end. Audio out level is quite low but a larger speaker would help in your application. Did not accurately measure current but seemed to be in 5 to 10 MA range in play back. Also I did stress the voltage to 8 Volts and while it might damage the ISD Chip long term, mine survived but audio was distorted so the circuit seems tolerant of voltage over the specified 5V.
product as descripted, easy to use, i recommande
Tested well
looks good for my project
Easy to use, plug in 3.3 volt power source and ground, push the record button and record your message. Play back the entire message with a single push of the PLAYE button, or part of the message by holding the PLAYL button. Also can be controlled by an Arduino or other microcontroller.
Przybył wcześniej niż przewidywano trudności. Moduły są pakowane pojedynczo w worki antystatyczne. Jeszcze ich nie wypróbowałem, ale wyglądają jak zdjęcia i wydają się być dobrej jakości towarem.
Wszystko na górze
Doskonały ptodukt i doskonała obsługa