Uchwyt wiertarski kluczowy samo-zaciskowy B16 1-16 mm z wrzecionem MT2-B16 do tokarki wiertarskiej
Część recenzji została przetłumaczona automatycznie.
Bardzo dobra mandril...warto każdego centa...wykonywanie bardzo dobrze zrobione
Produkt był pierwszej klasy opakowanie nie było bardzo dobre, ale element był tak dobrze zbudowany to nie mater
Dostarczenie fas, dobry produkt, bardzo solidny.
All good !
все хорошо, но диаметр шпинделя меньше чем диаметр посадочного гнезда патрона, примерно на 2 мм
Really pleased with this, it's nicely machined and the jaws close together perfectly so holding small drills will be no problem. The chuck feels very smooth when operating and is very nice to handle. Fairly quick delivery too !
Przybyli zgodnie z umową, polecam!
1-16mm B16 Self Tighten Keyless Drill Chuck With MT2-B16 Arbor... Delivery time - 5 Days. Within 3 - 7 days advertised. Package arrived in good condition, contents correct. After wiping off the coating of preserving oil/grease with methylated spirits; I then assembled the chuck and taper shaft with a couple of light taps with a hammer. Inserted the chuck and taper into my drill and tapped it home with a wooden mallet. After checking it was in firmly I turned on the drill to check how it ran, no wobble/run out detected. I inserted a Drillpro 10mm drill bit into the chuck and drilled a hole in soft material (plastic wood) to allow any wobble/run out to show in the result. As shown in the pic the hole was 10mm. The pic shows how I confirmed the diameter of the hole. Good value for money for home workshop use; I can recommend this item.
I receved the chuck no arbour with it
so good I am thinking of ordering another one